koi pond supply

By · Friday, October 30th, 2009

koi pond supply

There are many dangers Koi water quality. The biggies are ammonia and nitrite and to a lesser extent, nitrate. Some others that are important for knowledge are chlorine, chloramines, the pH balance and contaminants at random.

Both chlorine and chloramines can harm fish and can burn or kill plants pond. Also eliminate the beneficial nitrifying bacteria in the Koi pond.

Chlorine, which is a volatile gas, is decomposed with water circulation and exposure to air within 24-48 hours. Chloramines, however, take much longer to dissipate.

municipal water supplies have begun adding ammonia along with chlorine, resulting in longer lasting chloramines. If you add water to a municipal supply tank be sure to spray with a hose to add aeration to help break in and out of gas.

Another good option would be to let the water sit for a day or two before adding it to your pond to ensure that is not dangerous water quality Koi!

Sodium thiosulfate water removes chlorine and chlorine will run the chloramines. You can make a stock solution by the addition of four ounces of sodium Thioslufate crystals in a gallon of distilled water. One drop per gallon (50 ml per 1,000 gallons), with security, de-chlorinated your pond.

pH is a measure of whether water is acidic or alkaline. pH is measured on a scale of 1-14 with 7.0 being neutral

A pH range of 6 to 8.5 is considered acceptable for most pond life. The major concern associated with pH is its direct relation to the toxicity of ammonia and nitrite. For each number of pH above the neutral 7 is an increase of ten times in these toxicities.

When the pH of your pond drops below 7 is considered acidic. To raise the pH try adding baking soda or ground limestone.

If your pH above 8.5 Koi's immune system is stressed to the point of getting sick. A common cause of this may be cement or lime mortar discharging into the pond.

You need to watch out for an accident "pH." An accident of "pH" is when in a relatively short period of time the pH begins to decrease and will not stop until it reaches 5.5. This can happen overnight in a small pond. At a pH of 5.5 Koi begin to die within a few days.

Any time you see all the fish in the pond to start acting differently at the same time, you should suspect a drop of pH. If this happens you can raise the pH by adding 1 cup of baking soda per 1000 gallons of water and check and repeat each two hours until the pH is back to at least 7.0.

runoff water is the main way that pollutants that affect water quality entering Koi in the pond. Run-off water from a nearby stream or rainwater collection may contain toxic insecticides, herbicides and / or fertilizer.

Water rain from the roofs of metal or asbestos shingles will contaminate the pond and can be toxic to both their Koi and plants.

You will also want to be careful with their lawn care practices. Not use anything on the lawn or garden that does not want in your pond! Especially if the pond is on the lower ground level.

If you see white foam near the waterfall that may indicate a high level of dissolved organic compounds and must make some partial water changes and perhaps use an additive to help manage the increased organic load.

As you can see, you have to carefully monitor your pond water. If you are educated about what to test, when to test and signs of some of the most common problems that must be well equipped to maintain high water quality Koi!

To find out how you can take the best care of Koi water and Koi fish make sure to visit KoiCareBasics.com. You can also receive a free mini-course about Koi and pond care from long time Koi enthusiast and author Alan Deacon.

How to install a Disappearing Waterfall Part 1 | Pondliner.com

[affmage source=”ebay” results=”24″]koi pond supply[/affmage]
[affmage source=”amazon” results=”8″]koi pond supply[/affmage]
[affmage source=”clickbank” results=”4″]koi pond supply[/affmage]

 

Leave a Comment

You must be logged in to post a comment.